SUUNTO HIGH PRESSURE HOSE, SHORT

MIFLEX CARBON HOSE FOR PRESSURES UP TO 300 BAR / 4000 PSI; LENGTH 15 CM / 6 IN

Extremely durable and flexible high pressure hose for Suunto and any other brand Transmitters. Swivel not included.

Some choose to protect their wireless transmitter from damage while their set of gear is being picked up by fitting them to this short HP hose.

Miflex Carbon HD High Pressure Hose Features

• 7.8 mm Thin — 35% thinner than rubber hoses
• Lightweight — Half the weight of rubber hoses
• New electroless nickel-plated brass fittings
• Factory cleaned and nitrox ready

Miflex Carbon HD High Pressure Hose Specifications

The typical HP hose has a 7/16-inch UNF male fitting at the end that screws into the first stage regulator HP port, and a 7/16-inch UNF female fitting at the end that screws on to the SPG.

Female Fitting

• 7/16" x 20 UNF female threads
• Brass with electroless nickel plating
• Strain relief with shock absorber
• 14 mm deep air-spool/swivel-pin well

Male Fitting

• 7/16" x 20 UNF male threads
• Brass with electroless nickel plating
• Strain relief with shock absorber
• Viton O-ring

Hose Material

• New Graphite Carbon Black colour
• Less then 8 mm diameter
• Braided nylon exterior layer

Standard fittings: M 7/16" UNF, F 7/16" UNF

Working Pressure: 300 bar
Outside Diameter: 7.5 mm