You have no items in your cart.
Stay informed of the latest news and specials.
1 Ascension Place, Rosedale, Auckland 0632
Deliveries to: 5/20 Constellation Drive,
Rosedale,
North Shore,
Auckland 0632
Ph: +64 9 444 7698
Maximum of 6 rock lobster (both species combined) on any one day.
Except Te Arai Point, Auckland to Cape Runaway where a total of 3 spiny rock lobsters can be taken, and the remainder (up to 6 in total) can be packhorse rock lobster. If no spiny rock lobsters are taken at the same time, 6 packhorse lobsters can be taken.
Rules changing in CRA2 area from 1 July 2020
Measure the tail width in a straight line between the tips of the two large (primary) spines on the second segment of the tail. If you are unsure of the sex, use the 60mm measurement.
Measure the tail length along the underside in a straight line from the rear of the calcified bar on the first segment to the tip of the middle fan of the tail. Must have a tail length of at least 216mm (male and female).
There are rules and protections for gathering rock lobster/crayfish that cover: protected types, gathering methods, pot construction and use.
From Te Arai Point, Auckland to Cape Runaway telson clipping is required for all recreationally harvested spiny rock lobsters. The last third of the telson (central part of the tail fan) must be cut off so that it is noticeably shorter than the other sections of the tail fan. This must be done to all legal spiny rock lobsters as soon as they are taken.
Labelled diagram of a telson-clipped lobster [PDF, 551 KB]
Do not telson clip any packhorse rock lobsters.
MANUFACTURER: Dive Centre Ltd
CODE: BA001
PRICE:$130.00
During every Suunto Dive Watch battery change these steps are always performed...
1. Remove old O'Ring
2. Clean O'Ring sealing surface in back door
3. Clean O'Ring sealing surface on inside of watch
4. Check Battery Low
5. Power Draw Test
6. Replace Piezo Sticker - As Required
7. Re-Bend negative battery terminals - As Required
8. Test new battery level
9. Replace battery
10. Fit new Seal/O'Ring
11. Replace back door screws - As Required
12. Check buttons
13. Update firmware - As Required
14. Set Time & Date
15. Calibrate Digital Compass
16. Witschi Dry Leak test 30m
17. Wet Dive Test 30m+
18. Recalibration of pressure sensor if required
19. Check & Fit Strap and ready for pickup or delivery
All of this is performed in an ESD (Electrostatic Discharge) Protected work area by our Suunto Certified Technicians.
All Suunto watches must only be opened by our Suunto approved staff. No other store is approved to do this work, has the training or equipment to safely service your Suunto equipment.
Your Warranty is voided, damage or dangerous pressure sensor accuracy issues can occur if staff at any other store opens your watch.
Failure to do this can also cause Electrostatic damage or miscalibration of the pressure sensor (Which can endanger your life with incorrect depth and decompression calculations) and/or leaking that is not covered by warranty!
PLEASE DO NOT take your Suunto Dive Computer to a normal Jeweler - take it to your local dive store and make sure they use our services, or send it to us directly.
All details, prices and availability are subject to change - All rights reserved Dive Centre Ltd 1972-2024